GARAGISTIC STANDARD SHIFT SELECTOR JOINT

Overview

One of the most noticeable easy changes you can make to get rid of your BMW’s shifter slop is replacing your aging OEM selector joint! Our Garagistic selector joints are produced in-house from billet aluminum. We have taken the 30+-year-old BMW selector joint design and brought it up to date by swapping out the plastic stationary bushing for a precision sealed bearing assembly. By utilizing our new DSSR hardware that replaces the traditional pins and clips, this new design will allow you to snug the DSSR down on the selector joint without any binding and further eliminates any remaining slop in the shifter assembly.

We recommend replacing your selector joint every time you refresh the shifter components to ensure a consistent tight feel. Why not upgrade to the Garagistic Billet Selector Joint!

DO I NEED A SELECTOR JOINT, AND WHY?

The "standard" shift selector joint (BMW PN# 25117503525) will install on E30 Getrag transmissions running our short shifters. This is especially important on the E30 transmission that came from a car prior to 06/86 manufacture date. The earlier model shift selector joint has an offset cylinder and Selector Rod that is wider than the later model version. This earlier model does not fit a DSSR as the longer cylinder will not fit between the U cradle of the DSSR. As always with aging BMW parts, it is also advised to change the shift selector joint whenever you are performing maintenance on the shifter assembly. 

The aging BMW transmissions are generally showing their age and this selector joint ( BMW PN# 25117503525) has a plastic bushing that can wear out and cause slop. This selector joint is just one link in the system that can help tighten up your shifter feel and overall driving experience. Recommend changing these in the older BMW for maintenance. Mandatory to change the selector joint for use with a DSSR.

Fitment

WHAT CARS WILL THIS BMW SHIFT SELECTOR JOINT WORK IN?

• All E30 chassis (WILL NOT WORK WITH EARLY MODEL PRE 06/86 OEM SELECTOR ROD)
• Please Note: Factory OEM BMW selector rod pins may have slight variations in thickness and therefore some pins may have a tighter fit on our selector joints. This can be resolved with a quick cleaning (to remove grime and debris). In some cases, light sanding may be required.
• Our selector joints are a perfect fit for all of our DSSRs.

Replacement for early model and early chassis selector joints produced before 06/86

***IF YOU ARE UNSURE WHAT YOU NEED OR YOU HAVE OUR CHASSIS MOUNTED OR SUPREME OEM SHIFTER PLEASE CONTACT OUR SUPPORT TEAM BEFORE PLACING YOUR ORDER SO WE CAN ASSIST YOU IN PURCHASING THE CORRECT COMPONENTS FOR YOUR SHIFTER CONFIGURATION***